?unique=412a238&nocache=mydepot_wm_blue_soft)
Barcode:
43133
MyDepot product guide
Cora Double Bowl Single Drainer Sink 1180x480mm
A 1180 x 480 x 170mm topmount kitchen sink in 304 stainless steel. Features a left-hand bowl, secondary bowl, and single drainer with one tap hole.
What is included
| Included | Basket waste Rubber seal Mounting clips Cut-out template |
|---|---|
| Not included | Installation service and site preparation are not included unless stated separately. |
| Best for | Kitchens where double bowl capacity and a drainer section suit everyday food preparation and dish washing. |
Measure before you buy
- Confirm the cabinet width supports the 1180mm overall sink width.
- Check the cut-out dimensions before templating the benchtop.
- Confirm the tap hole position matches your mixer requirements.
- Confirm left-hand bowl and drainer orientation before ordering.
- Use a licensed plumber for final installation.
Complete specifications
| Product type | Kitchen Sink |
|---|---|
| SKU | 43133 |
| Code | 43133 |
| Size | 1180 x 480 x 170mm |
| Material | Stainless Steel |
| Colour / finish | 304 Stainless Steel |
| Mounting | Topmount |
| Barcode | 43133 |
Factory-direct confidence
MyDepot focuses on practical bathroom and home products with clear specifications and direct value. The goal is simple: make the renovation decision easier, not louder.
Care and installation notes
- Wipe the sink dry after each use to prevent water spots.
- Clean with mild detergent and a soft cloth only.
- Do not use steel wool, abrasive cleaners or bleach on the surface.
- Avoid pouring boiling fat directly into the sink.
- Do not use harsh chemicals or chloride-based cleaners on stainless steel.
FAQ
Does this sink include the basket waste?
Yes. The listing confirms a basket waste is included along with rubber seal, mounting clips and a cut-out template.
Do I need to confirm the cut-out size before installation?
Yes. The manufacturer cut-out template is a guide only. Always use the physical product measurements to confirm the benchtop cut-out before cutting.
Which side is the tap hole on?
The tap hole is on the left-hand bowl side. Confirm this suits your mixer choice and bench layout before ordering.